Viewing 1 post (of 1 total)
  • Author
    Posts
  • #15867
    esailor Team
    Keymaster

    C/E ORAL
    6th August 2018
    1.Type of ship and bore
    2.How do you check for engine performance?
    3.Draw a power card and draw card
    4 how do calculate engine power
    5. ship speed has dropped and engine power is same. Propeller slip and reasons
    6. difference between class and flag.
    7. chief engineer responsibilities under ISM
    8. what is ISM
    9. If the ship is grounded what are your actions. (tank soundings, crankshaft deflections, prop shaft alignment turn on turning gear and check amps.
    10 bunker procedure
    11. how to take samples.
    12 what samples do you take and fuel tests.
    13. what is BDN
    14. How long is BDN kept for.
    15. how long are samples kept for.
    16. how do you know that the barge is safe and not a security threat.
    17. 3 month prep for dry dock
    18. dock bottom inspections
    19. stern tube wear down and arrangements
    20. how do you take readings
    21. rudder inspections
    22. how do you take pintle clearances
    23. what carry the weight of the rudder
    24. what carry the weight of the bearing
    25. dry dock intervals
    26 have you done in water survey
    27 preparation for in water survey
    28 Documents to give to divers
    29 preparations for leaving dry dock
    30 how do carry out fire drills
    31 how many fire teams do you have
    32. what pressure are your BA bottles
    33 what maintenance do you do on your BA Bottle compressor (annual service from authorized contractors and air quality test)
    34 draw me your ship with all the fire boundaries.
    35. tell me about your ship structural protections
    36. how do you isolate your co2 system in drydock and why
    37 prepare for boiler survey
    38 what is done during boiler survey and what all will the surveyor check
    39 how a safety valve is overhauled and set
    40 internal inspections of water side and gas side (enclosed space)
    41 all lock out tag out procedures
    42 bringing the boiler back into service
    43 why do you do boiler water tests
    44 what tests do you do with values
    45 how is your engine mounted
    46 Critical equipment definitions and what are CE responsibility toward them
    47 are your engine critical equipment
    48 main switch board survey
    49 what tests are done on a MSB
    50 What’s on your fire plan
    51 you find damage to your hull what are your actions in dry dock
    52 where do you find the hull plate information
    53 how do you draw up the job specifications
    54 if there is pitting on the rudder what does it indicate
    55 what is cavitation
    56 class of bulkheads class A B C with standard fire tests and times
    57 where are they located on the ship.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.